Resolution of Cockpit Displays(Mirrors): 256 to 1024 Every Frame, Didn't notice any performance difference so I kept it at 1024 Every Frame. Shadows: OFF to High, About 6FPS decrease it isn't that much of a performance hit from no Aircraft Shadows to having a high detailed Aircraft Shadows. Heat Blur: OFF to High, Didn't notice any FPS decrease so I switched it to High to have the realistic After Burner/Engine Heat Blur at the back of the Jet. Visibility Range: Low to Ultra, 5-6FPS decrease buildings and objects can be seen from far away without needing to zoom to make them magically appear I recommend setting it to Ultra or Extreme. (Only noticeable when comparing side to side images) Water: Low to High, 20FPS decrease and didn't notice any water quality change high in the air so I put it on Low.
Traffic: Off to High, No FPS loss just low detailed vehicles driving on the road and going through tanks and anything placed with mission editor so I keep it OFF to not ruin my immersion when doing Air to Ground Missions. Terrain Textures: Low to High, I didn't notice any FPS or Graphical change even though the game restarted when changing the option so I don't know about this one so I kept it at High.Ĭiv. Textures: Low to High, About 1FPS decrease and cockpit looks way better I wouldn't recommend switching to Low unless you need every single FPS. Here are my results and findings tested on Caucasus map with the F/A-18C:
Note^: (Depending on the situation from being on the carrier on multiplayer with rainy weather to being 30,000ft in the Air) Memory Usage: 14.1-15.1 GB out of 16 GB (Turns out game uses SSD as Virtual Memory when RAM usage is almost full check out this guide and make sure you only enable file paging on SSD I set my to 32000/64000MB) Here are my current graphic settings with how my computer handled it: VR Headset: Oculus Quest 2 via Air Link 5408x2736 90Hz. <-Highly Recommended if you are using a hard drive SSD: Crucial M.2 1TB SSD 2400MB/s Reading Speed and 1800MB/s Writing Speed. This is my first time creating a guide so don't expect much from it.ĬPU: i5-7600K 4 Cores Overclocked to 4.5GHz. I was bored today and decided to go on DCS World and see which graphics settings have most impact on FPS so I did quick tests and on each option during testing my game kept crashing after loading few missions(Fixed in an update) so I hope it was worth it and here are my results and findings and what configuration I use. Hey everyone, I built my PC in 2017 to run DCS 1.5 and it ran it perfectly with no problems or FPS drops at Highest Graphic settings but then 2.5 came and I couldn't run my game at highest settings anymore so I had to downgrade the graphic settings and I still managed play the game/simulator with the same computer with good FPS for 4 years.
0 kommentar(er)
